Kraft Industrial Supply stocks the most commonly required gaskets for standard flanges in both spiral wound and compressed non-asbestos, boiler manway and handhole inspection plate gaskets in spiral wound, Topog-E® , and Blue-Max® , and standard elastomeric O-Rings in buna-N & viton. 

SPIRAL WOUND FLANGE GASKETS

Spiral wound gaskets form an extremely reliable, resilient, effective seal when compressed between two flanges.

 

SPIRAL WOUND BOILER GASKETS

Spiral wound boiler gaskets survive the most extreme temperature and pressure swings resulting from boiler start-up and shut-down.

SPIRAL WOUND BONNET GASKETS

Spiral wound gaskets without inner or outer guide rings are used where gasket is restrained by the subject equipment. Male/Female, Tongue/Groove, Valve  Bonnet Applications.

BLUE-MAX®  BOILER GASKETS

Blue-Max® gaskets provide all the durability, resilience and sealing properties of an asbestos boiler gasket without the asbestos.

 

TOPOG-E®  BOILER GASKETS

The original molded rubber gasket for steam, air and water to 380°F., and operating pressures to 180 PSI.

 

DIE-CUT GASKETS - STANDARD AND SPECIAL SIZES

Gaskets produced from flat sheet gasketing material and cut to standard Ring type and Full Face type gaskets dimensions from a variety of materials. We can produce custom gaskets to your specifications from a selection of materials in various thicknesses.

          Elastomeric seals available in a variety of materials and configurations in both standard off the shelf sizes and special non-standard constructions.